Philips hd3620 manual Cooling, LCD display, Temperature indication, Level indication

English 11

4Push down the blue locking levers until they are in horizontal position.

If you are unable to put the locking levers in horizontal position, you have not put the keg into the appliance in the right position.Take out the keg and follow steps 1 to 3 again.

,, After you have installed the keg (even the first time), the pump runs for a few seconds.

5Close the doors.

Cooling

After you have installed the keg, the appliance automatically starts to cool the keg. 

Note: At an ambient temperature of 23°C, chilling an uncooled keg takes 12-15 hours.

Tip:If you want to pour beer shortly after placing the keg in the appliance, prechill the keg in upright position in the fridge for a while before you install it.

For more tips, see chapter ‘Troubleshooting’.

1Wait until the beer has reached a drinking temperature of 4°C or below.

,, The temperature is shown on the display in green (see section ‘LCD display’ in this chapter).

LCD display

,, The display shows the temperature of the beer, the beer level inside the keg and the freshness of the beer.

Temperature indication

Wait until the temperature of the keg has dropped below 4°C before you start to pour beer.The ideal drinking temperature is 3°C.

The colour of the temperature displayed tells you if the beer has reached the right drinking temperature.

-- Red = the beer temperature is not yet ideal for consumption (above 4°C).The beer head may be too large.

-- Green = the beer has reached the right temperature (4°C or below) for consumption.

Level indication

The yellow-orange level indication on the display shows the amount of beer left in the keg in eight steps.

4222.001.9361.3.indd 11

08-02-10 10:52