English 13
In this way you remove all grease and soap residues, which allows you to pour a beer with a good head.
3Hold the glasses upside down to the light to check if they are free of grease and soap residues.
The glasses are clean when the water runs down the surface evenly, without revealing any stains.
Tip: If you clean beer glasses in the dishwasher, do not use a rinse agent. Rinse agent residues may break down the foam head of the beer.
Pouring beer
1You get the best results if you pour the beer in a cool, clean and wet glass!
Note: A cool glass ensures a more stable beer head. It also keeps freshly poured beer fresh longer and helps to retain its sparkling quality.
Note: For the best quality draft beer, always clean and rinse used glasses before you use them again.This prevents foam residues of previously poured beer from causing too much foam in freshly poured beer.
Note: When you have not poured beer for more than a week, it is recommended to let beer flow into the glass for 1 second.Then rinse the glass with cold water before you fill it with fresh beer.
2Hold the glass by the bottom or in the middle to make sure it stays clean.
3Open the tap in one quick, smooth movement.
The beer only flows properly into the glass if the tap is completely open. If the tap is only half open, the beer is forced through the tap, causing it to foam more strongly.
Let the beer to flow down the inside of the glass.
4To vary the size of the beer head, vary the angle at which you hold the glass under the spout and vary the distance between the glass
and the spout.
The more upright and the closer to the spout you hold the glass, the more foam you obtain.
Note: Do not let the end of the spout touch the beer glass, the beer or the beer head. Any beer residues present on the spout affect the forming of the beer head.
5Slowly move the glass to vertical position while you pour your beer.
6 Fill the glass until the foam almost flows over the rim of the glass. 7 Close the tap in one smooth movement.
Note: The pump may go on.
8Europe (except Germany and the UK): For the best end result, remove excess foam from the glass by moving a skimmer over the rim of the glass at an angle of 45° in one smooth movement.
