Pioneer Multi Player, CDJ-900 Rear Panel, Front Panel, About ejecting discs by force, English

PJOG MODE, VINYL mode indicator and CDJ mode indicator (page 17)

The mode switches between VINYL and CDJ each time this is pressed. The indicator lights when the VINYL mode is selected.

QSLIP (page 17)

RTEMPO ±6/±10/±16/WIDE (page 14)

SMASTER TEMPO (page 14)

TTEMPO (page 14)

UJog dial (– REV/+ FWD) (page 16)

VJog dial display section (page 10)

Rear Panel

WPOWER wON vOFF

Press to turn the power on and off.

XAUDIO OUT L/R (page 11)

YAC IN (page 11)

ZCONTROL (page 17)

AKensington security slot

BDIGITAL OUT

CLINK (page 11)

DUSB (page 11)

Front Panel

EDisc insertion slot

FDisc force eject pin insertion hole

About ejecting discs by force

!If the disc cannot be ejected by pressing [DISC EJECTh], the disc can be ejected forcibly by inserting the disc force eject pin all the way into the disc force eject pin insertion hole on the main unit’s front panel.

!When forcibly ejecting a disc, be sure to do so following the procedure below.

1Press [POWER] and wait at least 1 minute after the set’s power has turned off.

Never forcibly eject a disc directly after turning off the set’s power. Doing so is dangerous for the reasons described below.

The disc will still be spinning when ejected and could hit your fingers, etc., causing injury.

Also, the disc clamp will rotate in an unstable way, and the disc could get scratched.

2Use the included disc force eject pin. (Do not use anything else.)

The included disc force eject pin is mounted on the CDJ-900’s bottom panel. When the pin is inserted all the way into the insertion hole, the disc is ejected 5

mmto 10 mm out of the disc insertion slot. Grasp the disc with your fingers and pull it out.

English

En 9