Connecting the Unit
Connecting the Power Terminal
•Always use the recommended battery and ground wire, which is sold separately. Connect the battery wire directly to the car battery positive terminal
(+) and the ground wire to the car body.
•Recommended wires size (AWG: American Wire Gauge) is as follows. The battery wire, the ground wire and the optional direct ground wire must be same size.
•Use a 10 AWG to 20 AWG wire for the system remote control wire.
Battery Wire and Ground Wire Size
Wire Length | less than 2.1 m | less than 3.6 m | less than 5.2 m | less than 6.4 m |
Wire Size | 4 AWG | 2 AWG | 1 AWG | 0 AWG |
|
|
|
|
|
1.Pass the battery wire from the engine compartment to the interior of the vehicle.
•After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery.
The maximum length of the wire between the fuse and the positive (+) terminal of the battery is 45 cm.
|
|
|
| Engine |
| Interior of | ||||||||
|
|
|
|
| the vehicle | |||||||||
|
|
|
| compartment |
| |||||||||
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Positive (+) | Fuse 300 A |
|
|
|
|
| ||||||||
Drill a 14 | ||||||||||||||
Each amplifier must | ||||||||||||||
terminal | be SEPARATELY | mm hole into | ||||||||||||
|
| fused at 300 A. | the vehicle | |||||||||||
|
|
|
|
|
|
|
|
| body. | |||||
|
|
|
| Insert the | ||||||||||
|
|
|
| grommet into the vehicle | ||||||||||
|
|
|
| body. |
|
|
|
|
|
2.Expose the end of wires using nip- pers or a cutter.
•Battery wire, ground wire: 23 mm to 25 mm
•System remote control wire: 14 mm to 16 mm
3.Connect the wires to the terminal.
•Fix the wires securely with the terminal screws.
System remote |
| |
control terminal | Terminal | |
Power terminal | ||
screw | ||
| GND | |
Battery wire | terminal |
Ground wire System remote
control wire
WARNING
Failure to securely fasten the battery wire to the ter- minal using the terminal screws could cause the ter- minal area to overheat and could result in damage and injury including minor burns.
4.Put the wire ties in the slits and wrap the wire ties around the wires.
•Wrap the wire tie around the wire insulation, not the stripped wire.
•Cut off any excess portions of the wire ties.
Wire tie
9