Updating the TRAKTOR 2 software

When the computer is connected to the Internet, TRAKTOR 2 software can be updated by accessing the Native Instruments SERVICE CENTER (referred to simply as “SERVICE CENTER” below).

1 Launch the SERVICE CENTER and log in.

For instructions on launching the SERVICE CENTER and logging in, see Launching the SERVICE CENTER on page 4.

2 Click the [Update] tab.

Available updates are checked.

3 Check the check box.

Specify the update to be downloaded.

4 Click [Download].

Updating begins.

3From the [Help] menu on the upper left of the screen, open [Start Setup Wizard], then click [Next].

4At the [Are you using an external controller?] item, select [Yes], then click [Next].

English

Initial settings

The initial settings for TRAKTOR LE 2 can be made using the setup wizard (Setup Wizard).

Cautions

!For Windows users, this unit’s driver software must be installed in advance.

!All of TRAKTOR LE 2’s settings are reset to their defaults.

Before using, perform the following:

!Update this unit to the latest firmware version.

!For Windows users

Be sure to turn this unit’s power on before launching TRAKTOR LE 2. If this unit’s power is turned on after launching TRAKTOR LE 2, the DDJ-ASIO driver may not be recognized.

If the DDJ-ASIO driver is not recognized, close TRAKTOR LE 2 then restart this unit.

Setting procedure

1Connect this unit and the computer by USB cable, then slide the [ON/OFF] switch to the [ON] side.

2Once this unit starts up, launch TRAKTOR LE 2.

!Be sure to start up this unit before launching TRAKTOR LE 2.

5Select [Pioneer] at the [Choose your manufacturer] item and [DDJ-ERGO LE] at the [Choose your model] item, then click [Next].

!When using TRAKTOR PRO 2, select [DDJ-ERGO].

En 5