!Ifyou do not operate functions except for
Opendevice,SEARCH DEVICE,
DISCONNECT,DEVICEEDIT and
PINCODEINPUT within about 30 seconds, the
displayautomatically returns to the ordinary
display.
!Ifyou do not operate OPEN DEVICE and
SEARCHDEVICE within 30 seconds after the
Bluetoothdevice is paired, the display auto-
maticallyreturns to the ordinary display.
Using a Bluetooth device to pair1 Displaythe connection menu.
Referto Introduction to connection operations
onthe previous page.
2 UseMULTI-CONTROL to select
OPENDEVICE.
#Ifthere is previous connection log in this unit,
youcan select the Bluetooth device from
PAIREDDEVICE.
Referto Connecting a paired Bluetooth device and
selectinga service on the next page.
3 PushMULTI-CONTROL up or down to
selectthe special device.
#Bluetoothdevices that are difficult to establish
connectionis called special device. If your Blue-
toothdevice is listed in the special device, select
theappropriate one.
4 PressMULTI-CONTROL to open the con-
nection.
READYwill be displayed.
Thisunit is now on standby for connection
fromBluetooth device.
#Iffive devices are already paired,
MEMORYFULL is displayed and it is not possible
toperform the pairing operation. In this case, de-
letea paired device first. Refer to Deleting a paired
Bluetoothdevice on the next page.
#PushMULTI-CONTROL left or right to display
thedevice name, BD address and PIN code of
thisunit.
5 Useyour Bluetooth device to establish
connection.
Connectionmethod is different depending on
theBluetooth device. See the manual of your
Bluetoothdevice to establish connection.
Whenthe connection is established, PAIRED
isdisplayed.
#Ifthe connection fails, ERROR is displayed. In
thiscase, try again from the beginning.
#PINcode is set to 0000 as the default. You
canchange this code in the initial setting. Refer
toEntering PIN code for Bluetooth wireless con-
nectionon page 31.
Pairing from this unit1 Displaythe connection menu.
Referto Introduction to connection operations
onthe previous page.
2 UseMULTI-CONTROL to select
SEARCHDEVICE.
3 PushMULTI-CONTROL up or down to
selecta device.
4 PressMULTI-CONTROL to start search-
ing.
Whilesearching, SEARCHING flashes. When
availableBluetooth devices are found, device
nameor BD address (if names cannot be ob-
tained)is displayed.
#Tocancel searching, press MULTI-CONTROL
again.
#Iffive devices are already paired,
MEMORYFULL is displayed and it is not possible
toperform the pairing operation. In this case, de-
letea paired device first. Refer to Deleting a paired
Bluetoothdevice on the next page.
#Ifno device can be found, NOT FOUND is dis-
played.In this case, check the status of Bluetooth
deviceand search again.
5 PushMULTI-CONTROL up or down to
selecta device name you want to connect.
#Ifonly one device was found, this step cannot
beperformed.
Using Bluetooth wireless technology
En
28
Section
08