!If00 to 29, the minutes are rounded down.
(e.g.,10:18 becomes 10:00.)
!If30 to 59, the minutes are rounded up.
(e.g.,10:36 becomes 11:00.)
4 PushMULTI-CONTROL up or down to
puta clock right.
Switching the warning tone
Ifthe front panel is not detached from the
headunit within four seconds of turning off
theignition, a warning tone sounds. You can
turnoff the warning tone.
1 Displaythe initial setting menu.
Referto Adjusting initial settings on the pre-
viouspage.
2 UseMULTI-CONTROL to select
WARNINGin the initial setting menu.
3 PressMULTI-CONTROL to turn warning
toneon.
#Toturn warning tone off, press
MULTI-CONTROLagain.
Switching the auxiliary setting
Auxiliarydevices connected to this unit canbe
activatedindividually. Set each AUX source to
ONwhen using. For more information about
connectingor using auxiliary devices, refer to
Usingthe AUX source on page 45.
1 Displaythe initial setting menu.
Referto Adjusting initial settings on the pre-
viouspage.
2 UseMULTI-CONTROL to select AUX1/
AUX2.
3 PressMULTI-CONTROL to turn AUX1/
AUX2on.
#Toturn AUX off, press MULTI-CONTROL
again.
Setting the rear output andsubwoofer output
Thisunit’s rear output (rear speaker leads out-
putand RCA rear output) can be used for full-
rangespeaker (Rear SP:REAR) or subwoofer
(RearSP :SUB W)connection. If you switch
therear output setting to Rear SP:SUB W, you
canconnect a rear speaker lead directly to a
subwooferwithout using an auxiliar y amp.
Initially,the unit is set for rear full-range speak-
erconnection (Rear SP:REAR).
1 Displaythe initial setting menu.
Referto Adjusting initial settings on the pre-
viouspage.
2 UseMULTI-CONTROL to select REAR SP
inthe initial setting menu.
3 PressMULTI-CONTROL to switch the
rearoutput setting.
PressingMULTI-CONTROL will switch be-
tweenRear SP:REAR (full-range speaker) and
RearSP :SUB W(subwoofer) and that status
willbe displayed.
#Whenno subwoofer is connected to the rear
output,select Rear SP :REAR (full-range speaker).
#Whena subwoofer is connected to the rear
output,select Rear SP:SUB W (subwoofer).
Notes
!Evenif you change this setting, there is no
outputunless you turn the subwoofer output
on(refer to Using subwoofer output on page
40).
!Ifyou change this setting, subwoofer output
inthe audio menu will return to the factory
settings.
!Bothrear speaker lead outputs and RCA rear
outputare switched simultaneously in this
setting.
Initial Settings
En 43
English
Section
10