4 PushMULTI-CONTROL left or right to
selectthe desired level.
LOW(low)—MID (mid)—HIGH (high)
Using subwoofer output
Thisunit is equipped with a subwoofer output
whichcan be turned on or off.
Also,phase can be selected between normal
andreverse.
1 PressSW/BASS to display the subwoo-
fersetting mode.
PressSW/BASS repeatedly to switch between
thesubwoofer setting modes in the following
order.
SUBW1 (subwoofer on/off setting) setting
mode—SUBW2 (subwoofer setting) setting
mode
2 SelectSUB W1 setting mode.
3 PressMULTI-CONTROL to turn subwoo-
feroutput on.
NORMALappears in the display. Subwoofer
outputis now on.
#Toturn subwoofer output off, press
MULTI-CONTROLagain.
4 PushMULTI-CONTROL left or right to
selectthe phase of subwoofer output.
PushMULTI-CONTROL left to select reverse
phaseand REVERSE appears in the display.
PushMULTI-CONTROL right to select normal
phaseand NORMAL appears in the display.
Note
Youcan also switch to this setting mode in the
menuthat appears by using MULTI-CONTROL.

Adjusting subwoofer settings

Whenthe subwoofer output is on, you can ad-
justthe cut-off frequency and the output level
ofthe subwoofer.
!Whenthe subwoofer output is on, you can
selectSUB W2.
1 PressSW/BASS to display the subwoo-
fersetting mode.
PressSW/BASS repeatedly to switch between
thesubwoofer setting modes in the following
order.
SUBW1 (subwoofer on/off setting) setting
mode—SUBW2 (subwoofer setting) setting
mode
2 SelectSUB W2 setting mode.
3 PushMULTI-CONTROL left or right to
selectcut-off frequency.
50—63—80—100—125(Hz)
Onlyfrequencies lower than those in the se-
lectedrange are outputted from the subwoo-
fer.
4 PushMULTI-CONTROL up or down to
adjustthe output level of the subwoofer.
Eachtime MULTI-CONTROL is pushed up or
down,subwoofer level increases or decrease s.
+6to -24 is displayed as the level is increased
ordecreased.
Using the high pass filter
Whenyou do not want low sounds from the
subwooferoutput frequency range to play
fromthe front or rear speakers, turn on the
HPF(high pass filter). Only frequencies higher
thanthose in the selected range are output
fromthe front or rear speakers.
1 Displaythe audio menu.
Referto Introduction of audio adjustments on
page38.
2 UseMULTI-CONTROL to select HPF.
3 PressMULTI-CONTROL to turn high
passfilter on.
80Hzappears in the display. High pass filter is
nowon.
#Ifthe high pass filter has been previously ad-
justed,the frequency of that previously selected
willbe displayed instead of 80Hz.
Audio Adjustments
En
40
Section
09