Pioneer DEH-P65BT Adjusting loudness, Using subwoofer output, Using the high pass filter

	Section
Operating this unit	02

3Push MULTI-CONTROL up or down to select the desired Q factor.

Each time MULTI-CONTROL is pushed up or down, Q factor is selected in the following order:

2N—1N—1W—2W

Note

If you make adjustments, CUSTOM curve is up- dated.

3Push MULTI-CONTROL left or right to select the phase of subwoofer output. Push MULTI-CONTROL left to select reverse phase and REVERSE appears in the display. Push MULTI-CONTROL right to select normal phase and NORMAL appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

English

Adjusting loudness

Loudness compensates for deficiencies in the low- and high-sound ranges at low volume.

1Use MULTI-CONTROL to select

LOUDNESS.

2Press MULTI-CONTROL to turn loudness

on.

Loudness level (e.g., MID) appears in the dis-

play.

# To turn loudness off, press MULTI-CONTROL again.

3Push MULTI-CONTROL left or right to select a desired level.

Each time MULTI-CONTROL is pushed left or right, level is selected in the following order: LOW (low)—MID (mid)—HIGH (high)

1Use MULTI-CONTROL to select SUB W2.

# When the subwoofer output is on, you can se- lect SUB W2.

2Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50Hz—63Hz—80Hz—100Hz—125Hz Only frequencies lower than those in the se- lected range are outputted from the subwoo- fer.

3Push MULTI-CONTROL up or down to adjust the output level of the subwoofer. Each time MULTI-CONTROL is pushed up or down, subwoofer level increases or decreases. +6 to –24 is displayed as the level is increased or decreased.

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off.

1Use MULTI-CONTROL to select SUB W1.

2Press MULTI-CONTROL to turn subwoo- fer output on.

NORMAL appears in the display. Subwoofer

output is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

Using the high pass filter

When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are outputted from the front or rear speakers.

1Use MULTI-CONTROL to select HPF.

2Press MULTI-CONTROL to turn high pass filter on.

80Hz appears in the display. High pass filter is now on.

En 39