Pioneer DEH-P65BT operation manual Switching the warning tone, Switching the auxiliary setting

Operating this unit

Section

02

Switching the warning tone

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone will sound. You can turn off the warning tone.

1Use MULTI-CONTROL to select

WARNING.

2Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary equipments connected to this unit can be activated individually. Set each AUX source to ON when using. About connecting or using auxiliary equipments, refer to Using the AUX source on page 46.

1Use MULTI-CONTROL to select AUX1/ AUX2.

2Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL again.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (REAR SP:FULL) or subwoofer (REAR SP:SUB W) connection. If you switch the rear output setting to REAR SP:SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speak- er connection (REAR SP:FULL). When rear out- put is connected to full range speakers (when REAR SP:FULL is selected), you can connect other full range speakers (PREOUT:FULL) or a subwoofer (PREOUT:SUB W) to the RCA rear output.

1Use MULTI-CONTROL to select REAR SP.

2Press MULTI-CONTROL to switch the rear output setting.

Pressing MULTI-CONTROL will switch be- tween REAR SP:FULL (full-range speaker) and REAR SP:SUB W (subwoofer) and that status

will be displayed.

# When no subwoofer is connected to the rear

output, select REAR SP:FULL.

# When a subwoofer is connected to the rear

output, set for subwoofer REAR SP:SUB W.

# When the rear output setting is

REAR SP:SUB W, you cannot operate the follow- ing procedure.

3Push MULTI-CONTROL left or right to switch the subwoofer output or rear out- put.

Pushing MULTI-CONTROL left or right will switch between PREOUT:SUB W and PREOUT:FULL and that status will be dis- played.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 39).

!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.

Switching the sound muting/ attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

1 Use MULTI-CONTROL to select TEL.

English

En 43