Section
09Initial Settings for DVD player
Setting remote control code type
When the remote control operation switch is set to DVD, changing the remote control code type enables you to operate the Pioneer DVD player by the supplied remote control. There are three remote codes, code type A, code type B and code type DVH.
When using this unit with an
When using this unit with a DVD Navigation Unit, select code B (Not used).
When using this unit only, select code DVH.
1Set the remote control selection switch on the left side of the remote control to the appropriate position with a pen tip or other pointed instrument .
• If you select DVH mode, there is no need to take the following procedure.
• If you select A/B mode, take the following procedure and change the code type to the appropriate type.
2Pressing 7 and 0 on the remote control simultaneously changes the code type. Initially, the code type is set to A.
Each time you press 7 and 0 simultaneously on the remote control the code type changes between A and B.
If you forget your code number
Refer to Changing the Level, step 3 on page 66, and press CLEAR 10 times.
The registered code number is canceled, letting you register a new one. 
70En
