#Ifthe connection fails, ERROR is displayed. In
thiscase, check the cellular phone and try again.
#Ifthree cellular phones have already been
paired,the pairing assignment selection display
willappear. Select one assignment to pair the
newphone. The newly paired phone overwrites
thepreviously paired phone. The assignment se-
lectionoperation is the same as Step 3 to 4of
Pairinga connected cellular phone on this page ex-
ceptfor the operation below.
!Switchingthe BD address and device name
8 UseMULTI-CONTROL to decide to
downloadthe phone book from your cellu-
larphone or not.
PushMULTI-CONTROL left or right to select
NO(No) or YES (Yes).
PressMULTI-CONTROL to decide.
Whenyou select YES, this unit changes to
PHBOOK DOWNLOAD and the download op-
erationautomatically begins. After complet-
ing,DATA DOWNLOADED is displayed.
Accordingto the circumstances, this unit
changesto PH BOOK TRANSFER. In this case,
referto step 4 on Transferring entries to the
phonebook on page 39.
#Whenyou select NO, the display reverts to
normal.
Connectinga paired cellular phone
1 Displaythe connection menu.
Referto Introduction of connection and regis-
trationon page 29.
2 TurnMULTI-CONTROL to select
PAIREDPHONE.
#PushMULTI-CONTROL up or down to select a
desiredphone.
#PushMULTI-CONTROL left or right to switch
thedevice name, BD address, group name and
groupID.
3 PressMULTI-CONTROL to start connec-
tion.
Whileconnecting, CONNECTING is displayed.
Ifthe connection is established, CONNECTED
isdisplayed.
Afterconnected, this unit automatically
changesto PH. BOOK DL (phone book down-
loadconfirmation) display.
#Ifthe connection fails, ERROR is displayed. In
thiscase, check the cellular phone and try again.
4 UseMULTI-CONTROL to decide to
downloadthe phone book from your cellu-
larphone or not.
PushMULTI-CONTROL left or right to select
NO(No) or YES (Yes).
PressMULTI-CONTROL to decide.
Whenyou select YES, this unit changes to
PHBOOK DOWNLOAD and the download op-
erationautomatically begins. After complet-
ing,DATA DOWNLOADED is displayed.
#Whenyou select NO, the display reverts to
normal.
Disconnectinga cellular phone
1 Displaythe connection menu.
Referto Introduction of connection and regis-
trationon page 29.
2 UseMULTI-CONTROL to select
DISCONNECTPHONE.
3 PressMULTI-CONTROL to disconnect a
cellularphone from this unit.
Afterdisconnection is completed,
DISCONNECTEDis displayed.
Pairinga connected cellular phone
Pairingis usually performed automatically dur-
ingthe connection operation. You only need to
performthis operation manuallywhen your
phoneis connected temporarily for any r eason.
Werecommend you pair the phone to this unit
tomake best use of the technology.
1 Displaythe connection menu.
Referto Introduction of connection and regis-
trationon page 29.
2 UseMULTI-CONTROL to select
SETPHONE.
Operating this unit
En 31
Section
02
Operatingthis unit