Planet Technology VRT-401 Rear Panel, To Clear All Data and restore the factory default values

Introduction

Rear Panel

DMZ

Reset Button

WAN port (10/100BaseT)

10/100BaseT LAN connec- tions

Power port

Figure 3: Rear Panel

Use a standard LAN cable to connect a normal port on the other hub.

This button has two (2) functions:

∙Reboot. When pressed and released, VRT-401 will reboot (restart).

∙Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values.

To Clear All Data and restore the factory default values:

1.Power Off.

2.Hold the Reset Button down while you Power On.

3.Keep holding the Reset Button for a few seconds, until the RED LED has flashed TWICE.

4.Release the Reset Button. VRT-401 is now using the factory default values.

Connect the DSL or Cable Modem here. If your modem came with a cable, use the supplied cable. Otherwise, use a standard LAN cable.

Use standard LAN cables (RJ45 connectors) to connect your PCs to these ports.

Note:

Any LAN port on VRT-401 will automatically function as an "Uplink" port when required. Just connect any port to a normal port on the other hub, using a standard LAN cable.

Connect the supplied power adapter here.

5