THE PERFECT FIT

Handlebar Adjustment

Follow these steps to adjust the handlebars for a personal fit.

1Remove the handlebar cover to expose the handlebar and the four adjuster block bolts (A).

2Using a 7/16(11 mm) wrench, loosen the four nuts on the bottom of the adjuster block (turn handlebar to left or right for access to back nuts).

NOTE: It may be necessary to pry the adjuster blocks apart with a screw driver.

A

3Adjust the handlebar to the desired height. Be sure handlebars, brake lever and throttle lever operate smoothly and do not hit the gas tank, windshield or any other part of the machine when turned fully to the left or right.

4Torque the handlebar adjuster block bolts to 11-13 ft. lbs. (1.5-1.8 kg/m).

5Replace handlebar cover.

Backrest Adjustment

 

The passenger backrest on some

 

2

models is adjustable.

4

To move the backrest forward or

 

backward, lift the adjustment

 

lever on the left side (1).

 

When adjusting the backrest from

1

a passenger position to a single

 

rider position, rotate the backrest

 

cushion adjustment knobs (2)

 

until the proper angle is reached.

3

The grab bars have five height

adjustments. To raise or lower the

 

grab bar, remove the grab bar

 

 

adjuster knob (3), position the grab bar at the desired height, and reinstall the knob.

Some models are also equipped with passenger handwarmers. The switch (4), located under the left-hand wind deflector, has three settings: High, Off, and Low.

To lengthen or shorten the backrest cable, lift the cable until spring tension is felt and lock the jam nut.

59

Page 61
Image 61
Polaris 2002 manual Handlebar Adjustment