Precor 9.35 manual Custom Program Tips, Clearing the Settings in a Custom Program

Custom Program Tips

•The custom programs are time-based, you cannot select a distance or calorie goal.

•The duration of the custom program and the number of speed and incline settings is limited to available memory in the treadmill. The program does not end if the available memory is exhausted, but the display notifies you and further changes to speed or incline are not saved. Approximately, 1¹⁄₂ hours of recording time are available.

•You need to incorporate a cooling down period into your exercise session. The cool-down period is not automatically appended to the end of the custom programs.

•The program profile reflects changes to incline.

Clearing the Settings in a Custom Program

Perform the following steps to clear (delete) any speed and incline settings stored in a custom program.

1.At the Precor banner, select a USER key, and then press OK.

2.Display the custom program that you wish to clear.

Important: Clearing the speed and incline settings from a custom program permanently deletes them from memory.

3.While the custom program name appears on the display, hold the red STOP button for about fourteen seconds. After a message appears on the display indicating that the settings have been cleared, you can release the key. Speed and incline information are reset to zero.

During the 14-second delay and before CLEARING appears on the display, you can release the red STOP button and no change will occur to the custom program settings.

Owner’s Manual: Programs 44