Assembly Steps
CAUTION: The location of the On/Off switch is beneath the cutout on the base frame. Make sure the power switch is in the Off position. Make sure the power cord is disconnected from its power source.
Loosen, but do not remove, the two front fasteners and two side fasteners on the hood using the
Place the left upright support into the base frame side bracket. Ask your assistant to insert a socket head screw (A) into the top mounting hole on the front panel. Thread the screw so the other mounting holes line up. Then, secure the upright support to the side bracket using three socket head screws (A). Finger tighten.
Attach the right upright support by following the same procedure as step 2 using four socket head screws (A). Finger tighten.
Left Upright
Support
Right Upright
Support
9.3x | 3 |
