
C O M M E R C I A L P R O D U C T S D I V I S I O N
Setting Up the C764 Climber
You do not need any special knowledge or experience to set up a C764 climber, however you will need assistance. Ask for one or more assistants to help you assemble the climber.
INSTALLATION REQUIREMENTS
Follow the installation requirements below when installing the climber. If you do not install the climber according to the following guidelines, you could void the Precor limited warranty.
•Set up the C764 climber on a solid, flat surface. A flat surface is required for your safety and proper use of the climber.
•Fill out and mail the limited warranty card. The serial number is located on a label near the power receptacle.
•Use the appropriate voltage, dedicated circuit, and grounding as speci- fied on the climber. The C764 climber is available in a
CAUTION: Do not use a
ADDITIONAL TOOLS NEEDED
Obtain the following tools before assembling the C764.
❏Standard set of hex keys
❏
❏
❏⁷
ASSEMBLY INSTRUCTIONS
To assist you in the assembly of the climber, the items in the hardware kit, shown in Diagram 2, correspond to a particular letter in the alphabet. These letters appear throughout the assembly instructions. Refer to Diagram 2, while perform- ing the following steps:
1.Unpack the climber and remove the packing materials from the handrails, upper column support, display console, handlebars, and base frame assembly.
CAUTION: To avoid injury and ensure your safety, you need assis- tance to lift the climber off the pallet and place it on the floor. Do not drop the unit.
page 11