Precor owner manual Programmable Options on the C764 Climber, Changing the Club Settings

C O M M E R C I A L P R O D U C T S D I V I S I O N

Programmable Options on the C764 Climber

These next few pages provide information that lets you customize the C764 for your Club. It is not information that your customer needs to see. This section covers the following information about how to:

•select the units of measure

•set maximum workout and pause times

•customize a course

Note: If your customers are interested in the learning more about the C764, you may wish to direct them to the manual available on Precor’s web site (www.precor.com). (The manual, which appears on the web site, does not contain the information found in this section.)

CHANGING THE CLUB SETTINGS

The Club Custom Mode lets you customize your C764 climber with these features:

•Measurement system—You can choose between U.S. Standard or Metric. Typically, the climber you buy is set to U.S. Standard.

•Maximum workout time—You can set a workout time limit between 10 and 240 minutes in variable increments (see the list below). For example, if a you set the maximum workout time to 20 minutes, the climber allows users to specify a workout time from 10 to 20 minutes. Users could not specify a workout time longer than 20 minutes. When you buy the C764, the workout limit is set at 60 minutes. The incremental displays vary as shown below:

Time settings:	Displays increments of:	For example:
10 to 20 minutes	1 minute	11, 12, 13,...
20 to 60 minutes	5 minute	25, 30, 35,...
60 to 240 minutes	15 minute	75, 90, 105,...

•Custom courses (C764 only)—You can design two custom courses to meet your customers’ needs. A blank grid sheet, on page 28, provides a work sheet to help design your course.

Accessing the Club Custom Mode requires combining specific keys on the electronic console. This design helps secure the climber from unauthorized access and changes.

To use the Club Custom Mode, take the following steps:

1.Make sure that the climber is placed in an appropriate location and plugged in.

2.If necessary, turn ON the climber using the ON/OFF power switch. This switch is located near the power cable.

3.When the start-up prompt “PRESS ENTER FOR PROGRAMS OR PRESS QUICKSTART” appears, access the Club Custom Mode by simultaneously pressing all three CHANGE keys.

page 19