Precor C764 owner manual Reinsert screws and washers removed in step

C O M M E R C I A L P R O D U C T S D I V I S I O N

Diagram 8 Secure the handlebar bracket and handrail clamp to the upper column.

Vertical handlebar

Handrail

Handlebar bracket

Upper column

Heart rate cable

Handrail clamp

Reinsert screws and washers removed in step 5.

13.Align the holes in the handlebar bracket and the holes in the handrail clamp with the two holes in the upper column. Diagram 8. Insert the two screws with washers that were removed in step 5.

14.Replace the nylon-end nuts (removed in step 5) onto the end of the screws. Finger tighten the nuts while you hold the screws with a 3/16-inch hex key. Secure each nut by grasping it with a 1/2-inch box-end wrench (or crescent wrench) and tightening the screws with the hex key. Refer to Diagram 8.

15.Secure the handrails to the base assembly. Return to the lower handrail mounts and securely tighten the two screws (F). Hold onto the locknut (G) with a ⁷ -inch box-end wrench and tighten the screws using the appropriate hex key. Slide the handrail boot down over the screw and locknut. Refer to Diagram 5.

page 15