C O M M E R C I A L P R O D U C T S D I V I S I O N

2.Remove the climber from the shipping pallet. Be sure to remove the lag bolt that holds the climber on the pallet. The lag bolt is located under the right foot pedal next to the casing. Ask for assistance to lift the climber off the shipping pallet.

3.Make sure that the climber is unplugged and turned OFF. Do not assemble the C764 climber if it is plugged into a power outlet.

4.Take the following steps to secure the upper column to the base frame assembly. Refer to Diagram 3.

Diagram 3 Secure upper column to base assembly.

Handrail clamp

Upper column

Rubber boot

4 screws (A) with split lock washers (B) Upper column bracket

Mounting plate

Base frame

Use a 1/2-inch socket wrench to secure the upper column to base assembly.

a.Remove four split washers (B) four hex head screws (A) from in the Hardware kit. Place one split washer onto each screw.

b.Slide the rubber boot up the column to expose the mounting plate.

c.Position the upper column above the mounting plate so that the handrail clamp (on the upper column) faces the foot plates.

d.Align the holes and insert the four screws (A) through the upper column bracket and into the base frame mounting plate. See Diagram 3. Finger tighten each screw.

e.Obtain a 1/2-inch socket wrench and alternately tighten each screw until all four are tight against the bracket. Do not overtighten.

page 12

Page 12
Image 12
Precor C764 owner manual Diagram 3 Secure upper column to base assembly