Precor EFX manual Assembly Steps

Assembly Steps

Remove the packaging around the ramp support covers. Grasp the magazine rack at its base and slide it up and off the front ramp support cover. Set it aside.

Use a long-handle ⁵⁄₃₂-inch hex key to remove the four fasteners that secure the front ramp support cover. Set the fasteners aside.

A tab on each side of the front ramp support cover holds the front and back covers together. Gently squeeze the sides of the back covers to release the tabs. Remove the front ramp support cover.

While holding the foam pouch in place, ask your assistant to lift and hold the ramp while you position the lift motor assembly and slide the yoke into the ramp.

Note: The foam pouch has been placed over the end of the ramp to avoid scratches to the cover. The pouch will be removed once the stabilizers are attached and secure.

Secure the base of the ramp support assembly using two hex head screws (A), two split washers (E), and two washers (B). Finger tighten.

Secure the ramp to the yoke using two buttonhead screws (C), two washers (D) and two locknuts (G). Wrench tighten using the ⁷⁄₃₂-inch hex key and a ⁹⁄₁₆-inch socket wrench.

Return to the base of the ramp support assembly and wrench tighten the two fasteners using a ½-inch socket wrench.

536i Elliptical Fitness CrossTrainer Assembly Guide 5