Prepare the stabilizers for installation. Insert a clamp (O) into each stabilizer and secure it loosely with a buttonhead screw (L).
Thread a leveler (K) onto each stabilizer.
Note: Make sure the nut is fully threaded onto the leveler. Refer to the illustration.
For easier access to the base mounts, lift the front of the EFX off the floor and place a wedge of packaging beneath its base.
Ask your assistant to hold the stabilizer, which has the cable protruding from both ends, next to the moving arm assembly and base frame. While your assistant places the stabilizer on the pivot tube and wrench tightens the clamp, you can connect the base cable. An audible click is heard when the cable is properly attached. Insert the cable into its receptacle and place excess cable into the base frame.
Secure the stabilizer to the base frame using four hex head screws (A), four split washers (E) and four washers (B). Finger tighten.
Note: The split washers should be sandwiched between the head of the screw and the flat washers. Also, if you encounter difficulty aligning the base mounts, check the height of the levelers and adjust them accordingly.
Attach the opposite stabilizer to the metal shaft and wrench tighten the clamp. Secure the stabilizer to the base frame using four hex head screws (A), four split washers (E), and four washers (B). Finger tighten.
536i Elliptical Fitness CrossTrainer Assembly Guide | 8 |
