Pressure Systems 9022 user manual Auto UDP Broadcast@Reset , as hex state

Pressure Systems, Inc. NetScanner™ System (9016, 9021, & 9022) User’s Manual

Bit 6: SRAM Error.

03reserved

04reserved

05	Number of A/D Samples To Average, as hex value (e.g., 000A=10 decimal).	10
06	IP Address Resolution Method, as hex state: (default = 0000)	13
	0000 = Use Static IP Address stored in module’s non-volatile memory
	0001 = Get Dynamic IP Address from external RARP/BOOTP server
07	Host Response/Stream Back-Off Delay, as hex value (or FFFF). FFFF	14
	means use low-order byte of module’s Ethernet Address as value instead. In
	either case, back-off delay in microseconds is calculated from decimal
	equivalent of hex value:
	delay = decvalue * 20
08	Host Response/Stream Total Size Prefix (with 2-bytebig-endian binary	16
	value), added to all command responses and streams to indicate their true
	length in bytes:
	0000 = None (default)
	0001 = Yes
09	TCP Connect Port, as hex value (e.g. 2328 = 9000 decimal, default).	17
0A	Auto UDP Broadcast@Reset, as hex state:	18
	0000 = No (default)
	0001 = Yes
0C	Temperature Status of Each Scanner Transducer (9016 only), as 16-bit hex
	bit map, each bit representing the current status of a transducer/channel (16-1)).
	Bit values are:
	0= transducer operating within the specified operational limits.
	1= transducer operating outside the specified limits.
	(see end-of-table NOTE +)
0D	Minimum Temperature Alarm Set Point (9016 only)(in degrees C), as	19
	decimal (**) format 0 representation of internal IEEE float, with leading
	space).
0E	Maximum Temperature Alarm Set Point (9016 only)(in degrees C), as	19
	decimal (**) format 0 representation of internal IEEE float, with leading
	space).

3 - 56www.PressureSystems.com