Chapter 3 Configuring The KSSM Emulation With Control Codes
Reassign Bit-image Mode
ASCII Code | ESC ? n m |
Hex Code | 1B 3F n m |
Dec Code | 27 63 n m |
Purpose | Assigns the dot density used during the ESC K, ESC L, ESC Y, |
| or ESC Z commands to the density specified by parameter m in |
| the ESC * command. |
| Where: |
| n = 75, 76, 89, 90 |
| 0 <= m <= 40 |
Comment | The default settings are as follows: |
| ESC K is assigned density 0 |
| ESC L is assigned density 1 |
| ESC Y is assigned density 2 |
| ESC Z is assigned density 3 |
Select 1/6-inch Line Spacing
ASCII Code | ESC 2 |
Hex Code | 1B 32 |
Dec Code | 27 50 |
Purpose | Sets the line spacing to 1/6 inch. |
Comment | Changing the line spacing does not affect previous settings for |
| vertical tabs or page length. |
| This command affects the front panel setting of “Select LPI.” |
Select 1/8-inch Line Spacing
ASCII Code | ESC 0 |
Hex Code | 1B 30 |
Dec Code | 27 48 |
Purpose | Sets the line spacing to 1/8 inch. |
Comment | Changing the line spacing does not affect previous settings for |
| vertical tabs or page length. |
| This command affects the front panel setting of “Select LPI.” |
50
