Printronix PSA3, P7000 H-Series manual Set Left Margin

Chapter 3 Configuring The KSSM Emulation With Control Codes

Set Intercharacter Spacing Of SBCS Character (Hangul Extension)

ASCII Code	FS T n1 n2
Hex Code	28 54 n1 n2
Dec Code	1C 84 n1 n2
Purpose	Sets intercharacter space to the left and right of the SBCS
	character.
	n1	Specifies the space to the left of the printed character in
		1/180 of an inch.
	n2	Specifies the space to the right of the printed character in
		1/180 of an inch.

The units of n1 and n2 are 1/180 inch.

Where:

0 < n1 < 127

0 < n2 < 127

Comment A DBCS character with a half-width feature set by the FS SI command is treated as an SBCS character.

This command only affects SBCS characters when the FS V command is set.

The default is n1 = 0, n2 = 2.

Set Left Margin

ASCII Code	ESC I n
Hex Code	1B 6C n
Dec Code	27 108 n
Purpose	Sets the left margin to n columns in the current character pitch,
	as measured from the left-most printable column.
	Where:
	1 <= n <= 255
	0 < left margin < right margin
Comment	In DBCS mode, the character pitch is according to the width of
	the DBCS character.
	This command affects the front panel setting of “Left Margin.”
	The default depends on the power-up configuration.

70