PYLE Audio 7505-BTSDCMHC25 AC Wall Adaptor Model No. PS1050 G1, Powered Adaptor LED Stays Off

Chapter 6: Peripheral Devices & Accessories

Troubleshooting

6.6.5Troubleshooting

6.6.5.1 The Ikôn Charge Indicator LED Stays Off.

When an Ikôn is docked into a powered CH4004 and its charge indicator LED stays off, there could be a problem with the Ikôn or with the docking station. Use an Ikôn with a prop- erly functioning charge indicator to isolate the problem.

6.6.5.2 The Ikôn Charge Indicator LED Is Fast Flashing Green.

If the Ikôn charge indicator fast flashes green when the Ikôn is in any of the four sites:

•Remove the Ikôns and disconnect the adaptor DC power cable.

•Wait at least 20 seconds, and then plug the cable in again.

•If the Ikôn indicator still shows a fault, the Ikôn requires service.

6.6.5.3Green LED OFF When Connected To A Network.

•Check the Category 5/5e cable. Replace if the cable is suspect.

•Contact your network administrator.

6.6.5.4Yellow LED OFF When Connected To A 100Base-T Network.

•Check the Ethernet cable. Replace if the cable is suspect.

•Contact your network administrator to ensure the network is running at 100 Mbps.

6.6.5.5Powered Adaptor LED Stays Off.

•Check the AC cable. Replace with the same type if the cable is suspect.

•If the adaptor's LED stays OFF, the adaptor is defective and requires service.

6.7AC Wall Adaptor: Model No. PS1050 - G1

The AC wall adaptor available for your Ikôn allows you to operate your PDA using AC power while charging the battery inserted in the unit.

Adaptor plugs suitable for use in the following countries are shipped with the AC wall adap- tor: United Kingdom, Switzerland, Japan, Israel, Australia, Europe, and North America (see Figure 6.8 on page 231).

230Ikôn Rugged PDA (Windows CE 5.0) User Manual