PYLE Audio 7505-BTSDCMHC25 user manual Switching The Ikôn Off

Chapter 2: Basic Checkout

Switching The Ikôn Off

Note: If the unit was already in use—the unit may be off (suspend state)—pressing [ENTER] ‘wakes’ the unit from this state. The screen in which you were working prior to the suspend state is displayed. “GPS” on page 104 describes how you can assign other ‘wakeup’ keys or enable a two-key ‘power on’ sequence.

Important: If your Ikôn fails to power up, consider the following troubleshooting options:

The battery capacity may be too low (capacity < 100mAh), it may be over- heated (>60C°), a non-Psion Teklogix battery may be installed, or the battery may have fallen below the configured Suspend Threshold. See “Suspend Threshold And Estimated Battery Backup” on page 102

for details.

If you provide AC power to an Ikôn, and either the battery capacity is too low or the battery is overheated, a yellow LED will flash and the unit will not switch on. To switch on the PDA, you will need to replace the over- heated battery or, in the case of a depleted battery, wait for the capacity to reach an acceptable level.

However, if you supply AC power to an Ikôn with a battery that falls below the configured Suspend Threshold, the PDA will switch on.

2.3.3Switching The Ikôn Off

Important: Keep in mind that turning off the Ikôn does not result in a complete reboot; rather, the unit enters a power-saving, “suspend” state. When the unit is turned on from suspend state, operation resumes within a few seconds.

•To switch off the Ikôn, press and hold the Power button for five seconds. The Shutdown dialog box (Figure 2.4 on page 13) will appear for you to choose whether you want to Shutdown or Suspend.

12Ikôn Rugged PDA (Windows CE 5.0) User Manual