Quadra-Fire CASTILEI-MBK Listing and Code Approvals, A. Appliance Certification, Model, Laboratory

Castile Pellet Insert

1 Listing and Code Approvals

R

A. Appliance Certification E. BTU & Efficiency Specifications

MODEL:	Castile Pellet Insert-B
LABORATORY:	OMNI Test Laboratories, Inc
REPORT NO.	061-S-77d-6.2
TYPE:	Solid Fuel Room Heater/Pellet Fuel
	Burning Type Insert
STANDARD:	ASTM E1509-2004, ULC S628-93 and
	ULC/ORD-C1482-M1990 Room Heater
	Pellet Fuel Burning Type and (UM) 84-
	HUD, Mobile Home Approved

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the ASTM

E1509-2004, ULC S628-93, ULC/ORD-C-1482-M1990, (UM) 84-HUD

The Castile Pellet Insrt by Quadra-Fire is exempt from Envi- ronmental Protection Agency certifi cation under 40 CFR 60.531 y defi nition [Wood Heater (A) “Air to Fuel Ratio].

B. Mobile Home Approved

This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided.

The structural integrity of the mobile home fl oor, ceiling, and walls must be maintained. The appliance must be properly grounded to the frame of the mobile home and use only listed pellet vent, Class “L” or “PL” connector pipe.

A Quadra-Fire Outside Air Kit must be installed in a mobile home installation.

Note: This appliance is also approved for installation into a shop.

Particulate	0.7 grams/hr
Emissions Rating:
*BTU Output:	8,000 - 30,000 / hr
Heating Capacity:	up to 1,500 sq. ft. depending
	on climate zone
Hopper Capacity:	45 lbs
Fuel:	Wood Pellets or Shelled Corn
Shipping Weight:	252 lbs

*BTU output will vary, depending on the brand of fuel you use in your appliance. Consult your Quadra-Fire dealer for best results.

WARNING! Risk of Fire! Hearth & Home Technologies dis- claims any responsibility for, and the warranty and agency listing will be voided by the below actions.

DO NOT:

•Install or operate damaged appliance

•Modify appliance

•Install other than as instructed by Hearth & Home

Technologies

•Operate the appliance without fully assembling all components

•Overfire

•Install any component not approved by Hearth &

Home Technologies

•Install parts or components not Listed or approved.

•Disable safety switches

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

C. Glass Specifications

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

D. Electrical Rating

115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps

NOTE: Some generator or battery back-up systems may not be compatible with the micro-processor electron- ics on this appliance. Please consult the power supply manufacturer for compatible systems.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifi cations and/or price without notice.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

Page 4 7022-122 January 19, 2011