Castile Pellet Insert
R
have been obtained.
16.Thermostat
The appliance is designed to run on a 12 volt AC thermostat. The heat anticipator, if present, should be set on the lowest setting available.
17.Snap Disc #1 (Convection Blower) 110°F
Snap disc #1 is located on the right side of the fi rebox. There are 2 purple wires connected to it. This snap disc turns the convection blower on and off as needed. Power is always present at snap disc #1 if the stove is powered up.
18.Snap Disc #2 (Fuel Delivery Interrupt) 250°F
Snap disc #2 is located on the back side of the feed drop tube. There is 1 orange wire and 1 black wire connected to it. This snap disc will turn off the feed system, which will turn off the appliance if an overfi re condition should occur or if the convection blower should fail to operate. If this occurs the
snap disc with automatically reset itself.
19.Snap Disc #3 (Burn Back Protector) 250°F
Snap disc #3 is mounted on the back of the auger tube in the center of the appliance and has a reset button. To access it remove the right side panel. If the fi re tries to burn back into the feed system or push exhaust up the feed tube, this snap disc will shut the entire system off. This disc must be manually reset. Power is always present at snap disc #3 if the stove is powered up.
20.Vacuum Switch
The vacuum switch is located on the lower right side of the appliance behind left access panel. This switch turns the feed system on when vacuum is present in the fi rebox. The vacuum switch is a safety device to shut off the feed motor if the exhaust or the heat exchanger system is dirty or plugged or if the fi rebox door is open.
21.Wiring Schematic See Figure 42.1 below
Thermocouple | Thermostat |
|
|
|
|
|
|
Burn |
|
|
|
|
|
| |
Block |
|
|
|
|
|
| |
Selector |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Yellow |
| Vacuum | Hopper | Snap | Capacitor | Feed | |
| Switch | Switch | Disc #2 |
|
| Motor | |
Red |
|
|
| ||||
|
|
|
|
|
|
| |
Black |
|
|
|
|
|
|
|
White |
|
|
|
|
|
|
|
Red |
|
|
|
| Snap | Convection | |
Black |
|
|
|
| Disc #1 |
| Blower |
Black |
|
|
|
|
| ||
White |
|
|
|
|
|
|
|
Red |
|
|
|
|
|
|
|
Purple |
|
|
|
|
|
|
|
Gray |
|
|
|
|
|
| Exhaust |
Blue |
|
|
|
|
|
| |
|
|
|
|
|
| Blower | |
Black |
|
|
|
|
|
| |
Black |
|
|
|
|
|
|
|
Call | Snap | Reset |
|
|
|
|
|
Light | Disc #3 | Button | Fuse |
|
|
| |
|
|
|
|
|
| ||
Igniter |
|
|
|
|
|
|
|
Figure 42.1
Page 42 | January 19, 2011 |
