R
Mt. Vernon Pellet Insert (AE)
F. Glass Replacement
WARNING
•Glass is 5mm thick high temperature
•DO NOT REPLACE with any other material.
•Alternate material may shatter and cause injury
a.Swing open the face and remove door from the appli- ance by lifting door off of hinge pins and lay on a fl at surface face down.
b.Using a Phillips head screw driver, remove 4 screws 2 on the top and 2 on the bottom. Remove metal bracket and then remove the glass. Figure 41.1.
c.Replace with new glass with gasket.
d.
e.
G.Convection Blower Replacement
1.Follow the proper shut down procedures as outlined on page 35, Section 10.A.
Removal of Cast Sides
You will need to remove the cast sides in order to remove and replace the convection blower.
1.There is a latch on the back side of the cast side in the middle of the top opening of the cast side as indicated in Figure 41.2.
2.Place your fi ngers inside the opening and squeeze the latch. The side can now be pulled toward you and removed. Place on a protective surface so as not to damage the fi nish.
3.To replace the side, set the bottom in fi rst. Squeeze the latch in an open position. Place the cast side into posi- tion and then release the latch. The latch hooks onto a bracket to hold the side in place.
Remove 4 screws |
Metal Bracket |
Glass with Gasket |
Figure 41.1
Location of Latch for
Removing Cast Sides
Figure 41.2
Note: Instruction continue on page 42.
November 22, 2011 | Page 41 |
