Mt. Vernon Pellet Insert (AE)
H. Wall Control Thermostat Installation
1.When mounting the wall control thermostat on the wall, be sure to follow your wall control’s installation instruc- tions carefully.
NOTE: The wall control thermostat should be mounted on an inside wall and not in direct line with the appliance convection air.
NOTE: If the wall control thermostat is located too close to the appliance, you may need to set the temperature setting slightly higher to maintain the desired temperature in your home.
2.There is a 5 screw terminal block located on the back lower left corner of the appliance directly above the power cord inlet.
The center 3 screws are for the wall control thermostat wires and the 2 outer screws are mounting screw and should not have wires attached to them.
The thermostat wires are color coded. The green wire is on the top, the white in the middle and the red on the bottom. Figure 24.1.
There are colored dots corresponding with the same colored wire on the right side which are easily seen by the installer. If by chance it is put in upside down the dots will be on the left side and will not be visible.
CAUTION
Shock hazard.
•Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appliance.
R
12 volt Power Inlet (for optional battery
Houshold Power Inlet
Green Wire
White Wire
Red Wire
Thermostat Wires in Center 3 Screws
Figure 24.1
Page 24 |
| November 22, 2011 |
