Removal of Cast Sides | Quadra-Fire MTVERNINSAE-PMH instruction

Mt. Vernon Pellet Insert (AE)

C. Hearth Support

Included in Kit: (1) bottom, (1) trim front, (2) trim sides, (2) trim extensions

Tools Needed: Phillips head screw driver, measuring tape, gloves

1.Remove contents from box and lay on protective surface to avoid scratching the paint.

2. Lay front and sides face down. Bend the tabs down toward the inside. Figure 21.1.

3.The side pieces are shipped ﬂ at. It is must easier to ﬂ ex the sides into a bowed position before installing.

4.Lay the cast bottom face up. Attach the 2 sides FIRST and then the front piece. Figure 21.2.

5. Turn the cast bottom right side up and attach the panel extensions. Note the alignment hole.

6.Attach the appropriate footers depending on the panels & trim set you are installing. The footers come in 2 sizes, 3 and 5 inches. Discard the footers not used.

7. Place the assembled hearth support under the insert. Lower the leveling bolts if necessary to keep the insert level.

8.Open the door and attach the hearth support to the insert. There are 9 attachment holes. Figure 21.3.

9 attachment holes - 3 on each side and 3 in the front

Figure 21.3

Bend tabs down. Shipped

flat from the factory.

Figure 21.1

D. Removal of Cast Sides

You will need to remove the cast sides in order to install the panel and trim set.

1.There is a latch on the back side of the cast side in the middle of the top opening of the cast side as indicated in Figure 21.4.

2.Place your ﬁ ngers inside the opening and squeeze the latch. The side can now be pulled toward you and removed. Place on a protective surface so as not to damage the ﬁ nish.

3.To replace the side, set the bottom in ﬁ rst. Squeeze the latch in an open position. Place the cast side into posi- tion and then release the latch. The latch hooks onto a bracket to hold the side in place.

3 inch high Set Attach Trim to Insert from inside Insert.