Figure 43
Position the right wall all the way to back wall. Secure in position as was done in Step 2 (see Figure 44).
Figure 44
Replace the logs referring to your manual and log instruc- tions.
Step 10. Installing Trim, Logs and
Ember Material
Installing the Trim
Combustible materials may be brought up to the specified clearances on the side and top front edges of the fireplace, but MUST NEVER overlap onto the front face. The joints between the finished wall and the fireplace top and sides can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
!NEVER OBSTRUCT OR MODIFY THE AIR INLET/ OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as desired. Marble, brass, brick, tile, or other
Do not obstruct or modify the air inlet/outlet grilles. When overlapping on both sides, leave enough space so that the bottom grille can be opened and the trim door removed.
Positioning the Logs
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the instructions that accompany the logs. Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned slightly to avoid excessive flame impingement.
Shutter Settings |
|
|
Model | NG | LP |
| 3/16” | SET |
| 1/4” | SET |
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag labeled Mystic Embers is standard glowing ember material. To place the ember material:
•Remove the top louver by lifting it up and away from the unit.
•Unlatch the latches at the top and bottom of the glass door.
•Remove the glass door from the unit (see Figure 45).
•Place dime size pieces of ember material about 1/2 inch apart near port holes in burner top. Do NOT press em- bers into burner ports. Cover the top of the burner with a single layer of ember material (see Figure 46).
•Save the remaining ember materials for use during fire- place servicing. The bag of embers provided is sufficient for 3 to 5 applications.
•Reinstall and latch the glass door and top louver on the unit.
CAUTION: THE GLASS DOOR MUST BE SECURELY LATCHED BEFORE OPERATING THE UNIT.
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
Figure 45. Glass Assembly |
| |
GLASS SPECIFICATIONS: |
| |
24 5/8 x 35 3/8 | CERAMIC | |
21 1/8 x 30 3/8 | CERAMIC | |
EMBER MATERIALS
Figure 46. Placement of the Ember Material
36
