Appendix
11.3 Typical Slopes
The following slope settings are approximate and will vary depending on the metal alloy and surface finish, as well as the application. These are supplied here as examples.
Set the slope to approximately 1.000 for measuring the following metals with oxidized surfaces:
• Stainless Steel | • Cobalt | • Steel |
• Iron | • Nickel |
|
Set the slope to approximately 1.060 for measuring the following metals with smooth, clean, unoxidized surfaces:
• Iron | • Nickel | • Tantalum |
• Stainless Steel | • Rhodium | • Tungsten |
• Cobalt | • Steel |
|
• Molybdenum | • Platinum |
|
Molten iron also has an approximate slope setting of 1.060.
How to determine slope?
The most effective way to determine and adjust the slope is to take the temperature of the material using a probe sensor such as an RTD, thermocouple, or other suitable method. Once you determine the actual temperature, adjust the slope setting until the sensor’s temperature reads the same as the actual temperature reading. This is the correct slope for the measured material.
56 | Marathon Series FA/FR |
