Connections and Setup

Cordless Handset Installation

Installing the Charging Cradle and AC Adaptor

Plug the transformer end of the AC Adaptor into a standard AC electric power out- let, plug the other end into the “Power 5.5VDC In” jack on the back of the Charging Cradle.

Installing the Cordless Handset Battery

1.Locate the back cover and battery pack packaged separately from the Handset.

2.Insert the battery pack and connect the plug on the battery pack to the jack inside the compartment. Use only the supplied RCA Nickel Metal Hydride (Ni-MH) battery.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the compartment. To ensure proper battery installation, the connector is keyed and can be inserted only one way.

3.Close the battery compartment by pushing the back cover up until it snaps into place.

4.Place the handset in the charging cradle. Charge the battery for 12 hours before the first use.

NOTE: Allow the handset battery to properly charge (for 12 hours) prior to first use or when you install a new battery pack. If you do not properly charge the phone, battery performance will be compromised.

NOTE: The Cordless Handset may feel warm to the touch after charging.

Cradle

Handset

Battery

Black

Wire

Back Cover

16

Page 16
Image 16
RCA 25450 manual Cordless Handset Installation, Installing the Charging Cradle and AC Adaptor