PS-EX SE5
PS-EX SE6
English
6. Set up (PS-EX only)
4.Adjust the chain tension by turning the tensioner screw until the tie straps just touch the bottom side of the bar rail. (SE5)
(1)Chain tension adjusting screw
(a) Loosen
(b) Tighten
5.Tighten the mounting nut securely with the bar tip held up (TORQUE: 8.9~11.7 N.m./90~120
(1) Tighten
WARNING
It is very important to maintain the proper chain tension. Rapid wear of the guide bar or the chain coming off easily can be caused by improper tension. Especially when using a new chain, take good care of it since it should expand when first used.
■BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
6. Set up (HE-EX2 only)
HE-EX2
SE1
(B)
(A)
1.Attach the gearbox to the shaft tube as aligning the positioning holes and fasten the screw (A). Fasten the clamp bolt (B) firmly. (SE1)
(A)Screw
(B)Clamp bolt
(B)Tightning Torque: 70~130 in-lb (8~15 N.m)
26
