ResMed III & III ST user manual Starting Treatment, Ramp time

Starting Treatment

The VPAP unit should be assembled beside your bed with the air tubing and mask system connected. See “Setting Up The VPAP” on page 11.

1Turn the main power switch at the back of the unit to on (I).

Main power switch

When the VPAP is turned on, a welcome message is displayed on the LCD screen. The VPAP (or Ramp) screen then appears.

Note: If you have the HumidAire 2i attached, see “Using the HumidAire 2i Warm-Up Feature” on page 16.

2Fit your mask as described in the mask user instructions.

3Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.

CAUTION

! • Do not leave long lengths of air tubing around the top of your bed. It could twist around your head or neck while you are sleeping.

• Make sure the area around the flow generator is dry and clean. It should also be clear of bedding, clothes and other potential blockages.

4To start treatment, press the Front key or

if your clinician has enabled the SmartStart function, simply breathe into the mask and treatment will begin.

After starting treatment, you can display one of the treatment screens described in “Treatment Screens” on page 27.

Ramp time

Ramp time is a feature which can be enabled by your clinician. If you have difficulty falling asleep with full pressure, select a ramp time. The airflow will start very gently while you fall asleep. The pressure will slowly increase to full operating pressure over the selected ramp time. The clinician has set a maximum ramp time; you may select any value up to the maximum.

To select a ramp time, see “Ramp Screen” on page 21.

English

Starting Treatment 15