Paper and Other Media
❖OHP transparencies
• When printing on OHP transparency, use the bypass tray.
3 | TFWY060E |
•Load OHP transparencies into the tray with the print side down. Other- wise, it may stick to the fusing unit and cause a misfeed.
•Remove any unused OHP transparencies from the tray after you are fin- ished printing. Leaving them in the tray can cause them to curl.
•When printing on OHP transparencies, you should select the OHP trans- parency mode with the printer driver.
•The bypass tray can hold up to 50 OHP transparency sheets.
Note
❒The number of sheets to be set may vary depending on the paper thick- ness and paper type.
•When the “OHP SLIP SHEET” setting is set to “NO”, be sure to remove each OHP transparency immediately after it is printed. For more informa- tion, see the “Getting Started”.
Note
❒This printer uses paper in tray 1 for OHP slip sheet even if the direction and size of paper loaded in tray 1 is different from the direction and size of the OHP transparency. Check the direction and size of paper loaded in tray 1 before using “OHP SLIP SHEET” setting.
❒When there is no paper in tray 1, “OHP SLIP SHEET” will not work even if “OHP SLIP SHEET” setting is set to “YES”. Be sure to remove each OHP transparency immediately after it is printed.
22
