| Printer Doesn't Print |
|
|
|
|
|
|
Possible Cause | Solutions |
|
|
|
|
|
|
Is the Data In indicator | If not, the data is not being sent to the printer. Or the printer |
|
|
blinking after starting | may be resetting the print job because there was a long de- |
|
|
the print job? | lay in receiving the data from the computer. |
|
|
| ❖ If your printer is connected to the computer using the in- |
|
|
| terface cable |
|
|
| Confirm that the parallel port setting is set to on. |
|
|
| For more information on the printer port settings, see the |
|
|
| “Getting Started”. |
|
|
| ❖ If the printer is using the I/O timeout setting |
|
|
| Increase the value of the I/O timeout setting. |
|
|
| For more information on the the I/O timeout setting, see |
|
|
|
|
|
|
| the “Getting Started”. | 4 | |
|
|
| |
| ❖ Network Connection |
|
|
|
|
| |
| Contact your network administrator. |
|
|
|
|
|
|
| If the Data In indicator is blinking. |
|
|
| Take the following steps to correct the situation. |
|
|
| • Wait until the printer finishes receiving data from the |
|
|
| computer. |
|
|
| • Cancel the job if the data sent from the computer is too |
|
|
| large or complex. |
|
|
|
|
|
|
Can you print a test | If you cannot print a test page, it probably indicates a print- |
|
|
page (configuration | er malfunction. You should contact your sales or service |
|
|
page)? | representative. |
|
|
| If you can print a test page but cannot get the printer to print |
|
|
| when you issue a print command from your computer, it |
|
|
| probably means there is a problem with your computer. |
|
|
| Also keep in mind that large, complex data might take long |
|
|
| time for the printer process. For more information, see the |
|
|
| “Getting Started”. |
|
|
|
|
|
|
If you cannot solve the problem by taking the above actions, contact your sales or service representative.
33
