Ricoh G413 operating instructions To change the Skew tab settings

VRS Getting Started Guide

!To change the Skew tab settings

1 From the VRS Interactive Properties dialog box, select the Skew tab.

2Adjust the movable angle control arm until the image is straight:

a Use the mouse to select the vertical arm. When selected, the pointer changes to a hand icon.

b Move the arm counter-clockwise to rotate the image to the left, or clockwise to rotate it to the right. The Angle setting changes as the image rotates; the valid range is -45 degrees to 45 degrees.

3In the Angle box, you have two ways to adjust the Angle setting:

a Place your cursor in the Angle box, click the arrows to review the list of settings, and click your selection.

b Type a value for the correction angle directly into the Angle box. The valid range for the angle is -45 degrees to 45 degrees.

4Using the Fine Angle Adjustment Slider, you can fine-tune the deskew angle in single degree, or partial degree, increments, as follows:

a By moving the slider all the way to the left, you select a complete one-degree, counter- clockwise angle adjustment.

b By moving the slider all the way to the right, you select a complete one-degree, clockwise angle adjustment.

c By moving the slider to a position in between the leftmost or rightmost setting, you select an angle shift that is less than a full degree. Each line on the slider scale represents 5 percent of one degree.

30 Kofax Image Products