Connect PC to Scanner | Ricoh G413 manual

VRS Getting Started Guide

Connect PC to Scanner

Make sure switch 4 is down.

NOTE: Verify that the Dip Switches at the back of the “Scanner Control Unit” are in the configuration illustrated below.

Configure the Accelerator - Windows 95

After installing the Adrenaline Hardware Accelerator, power on your PC. Windows detects the Adrenaline Hardware Accelerator, and if you have successfully installed the VRS software, it automatically locates the drivers required by the accelerator.

6	Kofax Image Products

Image 10

Ricoh G413 operating instructions Connect PC to Scanner, Configure the Accelerator Windows

Contents

Ricoh Copyright Contents VRS Getting Started Guide Introduction Product Overview System Requirements VRS Product PackageScanner Install the Software InstallationTo install the VRS software Setup Complete Dialog Box Precautions Install the Adrenaline Hardware AcceleratorCompatibility with Current Accelerators and Engines Configure the Accelerator Windows Connect PC to Scanner Configure the Accelerator Windows NT Kofax Configuration Manager KCM Dialog Box Attach Your Scanner To connect the scanner to your PC Starting VirtualReScan To start VRS First Time Calibration Opening the VRS MenuTo open the VRS menu Select Source, Properties VRS Getting Started Guide Preview ConfigureReset Profile Defining Exception Conditions Cause Contrast Out of Range Threshold Selecting the ThresholdBrightness Out of Range Threshold Missing Corner Threshold Errors Tab Selecting an Action Error Description Action Options To define exception condition parameters Action Type Description Ignore manual mode only Rescan manual mode onlyVRS manual mode only Auto Resolve check box Stop Every Selecting a ModeStop on Errors Stop on First Updating Image Properties VRS Viewer with the VRS Interactive Properties Dialog Box Using the Zoom Menu to adjust the view Using the VRS ViewerUsing mouse buttons to adjust the view Using the VRS Interactive Properties Dialog Box VRS Interactive Properties Dialog Box Tabs VRS Interactive Properties Dialog Box Buttons Brightness and Contrast Visual Markers Using the Clarity TabBrightness and Contrast Black Lines Dotted Red Lines To change the Clarity settingsBlue Rectangle Gamma Using the Noise Tab To change the Noise settings VRS Getting Started Guide Using the Skew Tab Skew Tab To change the Skew tab settings Using the Profiles Tab To set up a profile To change the active profile To remove a profile from the Available Profiles list Automatic Deskew Using the Options TabImage Crop VRS Refresh Intelligent Contrast Adjustment / Brightness AdjustmentAccelerated Scanning To change the selections on the Options tab Using the Analysis Tab Analysis Tab Using the About Tab About Tab Previewing Images To preview an image Resetting VRS To reset the VRS configuration Technical Support Headquarters European HeadquartersPage Index Kofax Image Products VRS Getting Started Guide