Ricoh JP1210 Centre/Edge Erase-Erasing centre and Edge Margins, Check Indicator is blinking

SilverV-gb.book Page 18 Monday, May 15, 2000 3:32 PM

Operation

Centre/Edge Erase—Erasing centre and Edge Margins

1

18

When printing from thick books, or similar originals, the binding margin at the centre and the edges might ap- pear on prints. To prevent this, follow the steps below.

GRMARG0E

Note

❒As a default setting, the paper sizes and directions that can be used are as follows:

Metric	B4L, A4L, A5K,									A5L,
ver-	B5K, B5L
sion
Inch	8	1	/2"	×	14"	L	, 8	1	/2"	×	L
ver-										11"	,
	51/2" × 81/2"L, 51/2" ×
sion	81/2"K

❒If you want to use other size origi-

nals, you can register the size using Service Program mode (See ⇒ P.59 “Service Program Menu”).

❒The margin width to be erased can

be adjusted with Service Program mode (See ⇒ P.59 “Service Program Menu”).

A Press the {Center/Edge Erase} key twice to select the Centre/Edge Erase mode.

Check Indicator is blinking and

is shown in the guidance dis- play.

Note

❒To cancel this mode, press the

{Center/Edge Erase} key again.

B Press the {} or {} key to se- lect the paper size and direction.