Ricoh JP1250, JP1210 operating instructions Skip Feed Printing

SilverV-gb.book Page 37 Monday, May 15, 2000 3:32 PM

Skip Feed Printing

Skip Feed Printing

If the backs of prints are dirty, you	C
can increase the time between two
prints using the {Skip Feed} key. In
the default setting, when one sheet of
paper is fed the drum rotates twice.
However, you can select the number
of rotations of the drum. This gives
you the chance to remove prints one
by one from the paper delivery tray
or insert one sheet of paper between
two prints.
A Set your originals on the exposure	D
glass or in the optional document
feeder.

B While holding down the {Skip Feed} key, select the number of rotations of the drum while one sheet of paper is fed with the number keys.

E

Note

❒You can select from 1 to 9 rota- tions.

❒The beeper sounds after you set the number of rotations.

Press the {Start} key.

1

TSLS012E

Check the image position of the trial or proof print.

Note

❒If the image position is not cor- rect, adjust it using the {Image Position} keys (see ⇒ P.9 “Shift- ing the Print Image Position For-

ward or Backward”) or the side tray fine adjusting dial (see ⇒ P.10 “Shifting the Print Image Po- sition to the Right or Left”).

Enter the number of prints with the number keys.

TSLS011E

F Make your prints.

37