RoboteQ AX500 manual Transmitter/Receiver Quality Considerations, Joystick Deadband Programming

R/C Operation

Note: the Accessory Outputs C will be turned Off when radio is lost.

Important Notice about PCM Radios

PCM radios have their own watchdog circuitry and will output a signal (normally a “safe condition” value) when radio communication is lost. This signal will be inter- preted by the AX500 as a valid command and the controller will remain active. To benefit from the AX500’s radio detection function, you will need to disable the PCM radio watchdog.

R/C Transmitter/Receiver Quality Considerations

As discussed earlier in this chapter, the AX500 will capture the R/C’s command pulses with great accuracy. It will therefore be able to take advantage of the more precise joysticks and timings that can be found in higher quality R/C radio, if such added precision is desired in the application.

Another important consideration is the R/C receiver’s ability to operate in an electrically noisy environment: the AX500 switches high current at very high frequencies. Such tran- sients along long battery and motor wires will generate radio frequency noise that may interfere with the R/C radio signal. The effects may include reduced remote control range and/or induced errors in the command pulse resulting in jerky motor operation.

A higher quality PCM R/C transmitter/radio is recommended for all professional applica- tions, as these are more immune to noise and interference.

While a more noise-immune radio system is always desirable, it is also recommended to layout the wiring, the controller, radio and antenna so that as little as possible electrical noise is generated. Section “Electrical Noise Reduction Techniques” on page 31 provides a few suggestions for reducing the amount of electrical noise generated in your robot.

Joystick Deadband Programming

In order to avoid undesired motor activity while the joysticks are centered, the AX500 sup- ports a programmable deadband feature. A small deadband is set in the controller by default at the factory. This deadband can be stretched, reduced or eliminated using the Roborun utility. The AX500 has 8 preset deadband values coded 0 to 7. The value 0 dis- ables the deadband. Other values select a deadband according to the table below. The deadband value applies equally to both joysticks.

88 AX500 Motor Controller User’s Manual Version 1.9b. June 1, 2007