RoboteQ manual AX500 Quick Start, Power Must be con, Nected to VCon, VMot for the controller

AX500 Quick Start

The front side contains the 15-pin connector to the R/C radio, joystick or microcomputer, as well as connections to optional switches and sensors.

Connector to Receiver/

Controls and sensors

Status LED

FIGURE 1. AX500 Controller Front View

At the back of the controller (shown in the figure below) are located all the that must be connected to the batteries and the motors.

Note:

Both VMot terminals are connected to each other in the board and must be wired to the same volt- age.

Power Must be con-			VCon
nected to VCon and	VMot M2+ M2- 3 x Gnd			M1- M1+ VMot
VMot for the controller		Motor 2			Motor 1
to operate

FIGURE 2. AX500 Controller Rear View

14 AX500 Motor Controller User’s Manual Version 1.9b. June 1, 2007