62
39: GUITAR AMP SIMULATOR
This is an eect that simulates the sound of a guitar amplier.
L in
R in
L out
R out
Pan R
Pan L

Pre Amp Speaker

Parameter Value Explanation
Pre.Amp.Sw OFF, ON Turns the amp switch on/o.
Pre.Amp.Type
JC-120,
CLEAN TWIN,
MATCH DRIVE,
BG LEAD,
MS1959I,
MS1959II,
MS1959I+II,
SLDN LEAD,
METAL 5150,
METAL LEAD,
OD-1,
OD-2 TURBO,
DISTORTION,
FUZZ
Type of guitar amp
Pre.Amp.Volume.# 0–127 Volume and amount of distortion
of the amp
Pre.Amp.Master.# 0–127 Volume of the entire pre-amp
Pre.Amp.Gain LOW, MIDDLE, HIGH Amount of pre-amp distortion
Pre.Amp.Bass
0–127
Tone of the bass/mid/treble
frequency range
Middle cannot be set if “MATCH
DRIVE” is selected as the Pre Amp
Type.
Pre.Amp.Middle
Pre.Amp.Treble
Pre.Amp.Presence 0–127 Tone for the ultra-high frequency
range
Pre.Amp.Bright OFF, ON
Turning this “On” produces a
sharper and brighter sound.
This parameter applies to the
“JC-120,” “CLEAN TWIN,” and “BG
LEAD” Pre Amp Types.
Speaker.Sw OFF, ON
Determines whether the signal
passes through the speaker (ON),
or not (OFF).
Speaker.Type (See the table below.) Type of speaker
Mic.Setting 1, 2, 3
Adjusts the location of the
microphone that’s capturing the
sound of the speaker.
This can be adjusted in three
steps, from 1 to 3, with the
microphone becoming more
distant as the value increases.
Mic.Level 0–127 Volume of the microphone
Direct.Level 0–127 Volume of the direct sound
Pan.# L64–63R Stereo location of the output
sound
Level.# 0–127 Output Level

Specications for each Speaker Type

The speaker column indicates the diameter of each speaker unit (in inches) and the
number of units.
Type Cabinet Speaker Microphone
SMALL.1 Small open-back enclosure 10 Dynamic
SMALL.2 Small open-back enclosure 10 Dynamic
MIDDLE Open back enclosure 12 x 1 Dynamic
JC-120 Open back enclosure 12 x 2 Dynamic
BUILT-IN.1 Open back enclosure 12 x 2 Dynamic
BUILT-IN.2 Open back enclosure 12 x 2 Condenser
BUILT-IN.3 Open back enclosure 12 x 2 Condenser
BUILT-IN.4 Open back enclosure 12 x 2 Condenser
BUILT-IN.5 Open back enclosure 12 x 2 Condenser
BG.STACK.1 Sealed enclosure 12 x 2 Condenser
BG.STACK.2 Large sealed enclosure 12 x 2 Condenser
MS.STACK.1 Large sealed enclosure 12 x 4 Condenser
MS.STACK.2 Large sealed enclosure 12 x 4 Condenser
METAL.STACK Large double stack 12 x 4 Condenser
2-STACK Large double stack 12 x 4 Condenser
3-STACK Large triple stack 12 x 4 Condenser
40: COMPRESSOR
Flattens out high levels and boosts low levels, smoothing out uctuations in volume.
L in
R in
L out
R out
Compressor
2-Band EQ
2-Band EQ
Compressor
Parameter Value Explanation
Attack.# 0–127
Sets the time from when the
input exceeds the Threshold
until the volume starts being
compressed
Threshold.# 0–127 Adjusts the volume at which
compression begins
Post.Gain 0–+18 dB Adjusts the output gain.
Low.Gain -15–+15 dB Gain of the low range
High.Gain -15–+15 dB Gain of the high range
Level.# 0–127 Output Level