Rose electronic MAN-VR2 manual Logging and Status, Name, Users, Hotkey / KVM Port

It is recommended that the naming and hot key assignments for each Host Configuration entry match the CPU port configuration of the Vista Remote 2.

Entry #1 - Name and hot key defined to switch to CPU port #1, Entry #2 for CPU port #2, etc. Examples of Hot key sequences for switching to a given port are shown below.

Name

Enter the name that will be displayed in the viewer window when you click the Host button.

Users

Select the users that will be permitted to connect to this host. Either enter * to allow all users or a list of users separated by commas (e.g. sales, admin, eng, david). Names must be set-up on the user accounts menu and match these names.

Hotkey / KVM Port

Declare the hot key sequence, or Remote Port Direct address that will cause the KVM switch module to link with the required host system. Remote Port Direct addresses must be entered within square brackets. To set-up the hotkey values used to switch to a given CPU port, the following information is used to create the hot key sequence:

+means press down the key that follows

–means release the key that follows

+– means press down and release the key that follows

To switch to CPU port #1, the Hotkey / KVM port sequence would be +-Ctrl+-1+-Enter, to switch to CPU port #8, the sequence would be +-Ctrl+-8+-Enter. A list of the valid hotkey codes are given in Appendix I.

Logging and Status

This screen provides various details about the user activity on the Vista Remote 2.

Note: The log has a maximum capacity of 1000 event lines. After 1000 entries, the oldest entries are overwritten. If log data are important to your installation, ensure a regular backup procedure or use the Syslog Server IP Address option to send log information automatically to another system.

22

Vista Remote 2 Installation and Operations Manual