Rose electronic MAN-VR2 manual Keyboard Commands, Keyboard commands

Keyboard Commands

Keyboard commands can be used to further customize the KVM switch module. These commands can be invoked directly from a local or remote keyboard or from the “Command, Keyboard commands” tab on the VNC view toolbar. (To use the keyboard commands, you must be connected via the VNC viewer, not the java applet)

The commands listed in the “Key sequence / Hotkey Command” column are: TOP - direct keyboard command /

BOTTOM - key sequence string to add to the “Command, Keyboard Command OSD menu”

Command	Key Sequence /	Description
	HotKey Command*
Invoke the On	<Ctrl> F12	Displays the KVM switch module’s on-
Screen Display	+-ctrl+-f12	screen display
List computers	<Ctrl> Esc	Provides a list of connected computers
	+-ctrl+-esc	to connect to
Reset command	<Ctrl> R	Resets and enables mouse and
	+-ctrl+-r	keyboard, enables PS/2 mouse on
		currently selected port.
Reset mouse	<Ctrl> O	Sends reset mouse command to
command	+-ctrl+-o	currently selected CPU. Will recover
		stuck NT mouse.
Send null byte	<Ctrl> N	Used to re-synchronize PS/2 mouse.
	+-ctrl+-n
Identify ROM	<Ctrl> I	Identifies ROM version, CPU must be at
version	+-ctrl+-i	a command prompt, word processor, or
		text editor to receive value.
Keep	<Ctrl> K	Saves current scan state and custom
	+-ctrl+-k	settings.
Scan time interval	<Ctrl> Txx <Enter>	Sets the pause time for each port when
	+-ctrl+-txx	scanning.
	(xx = 1 – 16 sec.)
Mode command	<Ctrl> M x <Enter>	First select the CPU port to configure,
	+-ctrl+-mx	and then enter the mode command.
	Where:	Mode 1, 2, 3 for keyboard:
	x = 1,2,3,7,8,9	Mode 7, 8, 9 for mouse
	for modes 1-9
Maximum	<Ctrl> P x <Enter>	Limits scanning to maximum port
computers	+-ctrl+-px	number
	(x = 1 – 4 or 1 – 8)
Typematic value	Factory setting = 43	See Attachment H.
	Rate = 10.9 chars/sec
	Delay = 500 millisec.
Mouse type	<Ctrl> Q x <Enter>	First select the CPU port, and then enter
	+-ctrl+-qx	the type command
	Where:
	x = 0 for PS/2 mouse
	x = 1 for Serial mouse
	x = 2 for Wheel mouse

* See the “Controls” tab section for entering the hotkey commands

Keyboard commands (continued)

Vista Remote 2 Installation and Operations Manual 39