Runco XP-65DHD manual RS-232 Connection from the DHD Controller to the PlasmaWall

Installation

Digital Video Connection: The PlasmaWall has a dual HDMI input board, labeled HDMI (SLOT 2). Connect the HDMI output from the DHD Controller to input “A” on this board, using an HDMI-to-HDMI cable.

Some PlasmaWall XP Series models have a DVI input board (labeled DVI-D IN (SLOT 2)) in place of the dual HDMI input board. Connect the HDMI output from the DHD Controller to this input, using a DVI-to-HDMI cable or equivalent cable/adapter combination.

RS-232 Connection: Connect the RS-232 output from the DHD Controller to the

SERIAL input on the PlasmaWall. Use a standard, modular telephone cable with RJ11 plugs at both ends. On the PlasmaWall end, use the provided RJ11-to-DB9 adapter. This adapter is wired as shown in Figure 3-6.

	4	XMT DATA		RCV DATA	3	PlasmaWall
	3	RCV DATA		XMT DATA	2	1	5
		SIG GND		SIG GND
To/From	2, 5				5
DHD				REQUEST TO SEND		6	9
Controller					8
				CLEAR TO SEND		SERIAL
					7
	1, 6		NO CONNECTION
					1, 9

DB-9 Female

RJ-11 Male

Figure 3-6. RS-232 Connection from the DHD Controller to the PlasmaWall

24 PlasmaWall XP Series Owner’s Operating Manual