Russound CAM6.6X-S1/S2 instruction manual Learn IR LrnIR, Learned SRC

INSTALLER

INSTALLATION MENU

6.POWER OFF CMD – (OfCmd)

7.COMMAND TYPE – (CmdTp)

a.Selected: Learned IR (LrnIR)

i.LEARNED SRC – (LnSrc)

b.Selected: Unassigned (Unasg)

c.Selected: Default (Deflt)

d.Selected: Macro:

i.MACRO – (Macro)

ii.MACRO ID – (MacID)

e.All Other Selections:

8.DEVICE CODE – (DevCd)

9.KEY FUNCTION – (KeyFn)

10.SAVE CHANGES? – (Save?)

Tells the controller to turn off the selected source equipment (by SOURCE NUMBER) when the last of the UNO System Keypads is turned off. If “no,” procedure advances to SAVE CHANGES (step 10)

Select the type of source command (e.g., CD, TV, etc.).

Choose Learned IR if the pre-programmed IR code library does not support the source component.

Select the learned source bank to be assigned to the source component. Procedure advances to KEY FUNCTION (step 9)

The Power Off command is cleared. Procedure advances to SAVE CHANGES (step 10)

Default selects the same device type and device code previously setup in BASIC SETUP. Procedure advances to KEY FUNCTION (step 9)

(To build macros, see Macro Editor page 65)

Macro loads a series of commands which are processed when activated.

Enter the macro ID number.Menu advances to SAVE CHANGES (step 10)

Procedure advances to DEVICE CODE (step 8)

Source component code for IR control.

Select Keypad function.

Select “yes” to save the changes.

LEARN IR (LrnIR)

This procedure allows IR commands to be learned into the system and be centrally stored in the main controller to let the system access the same IR codes that operate the source equipment.

NOTE: IR codes must be learned in by pointing the remote at the CAM6.6’s REAR panel IR receiver only. See Learn IR - Flow Chart page 77

1. LEARNED SRC –	Select the source (Source 1-6 and Miscellaneous Learned IR
(LnSrc)	(Misc)) whose commands will be learned into the controller.

64